У зв'язку зі святкуванням Нового Року ми працюємо за наступним графіком: • з 31.12.24(Вт) по 02.01.25(Чт) не працюємо • з 03.01.25(Пт) працюємо в звичайному режимі.
Інтерет-магазин приймає замовлення цілодобово 24/7 !
Web Speech API is not supported by this browser. Install Google Chrome.
Voice input also works in Safari, Yandex, as well as mobile browsers Huawei, Opera and Samsung..
PLASTIK HIGH VISCOSITY is a high viscosity varnish based on acrylic resin, especially suitable for electronics. Forms a shiny flexible protective layer that resists acids, salts, mold, corrosive fumes, alcohols, thermal and mechanical stress, alkalis, moisture and other manifestations of an aggressive environment. The coating remains effective over a wide temperature range from –70°C to+120°C. PLASTIK HIGH VISCOSITY forms a stable film on metals, plastics, wood, glass, etc. Does not drain and allows soldering through the protective layer.
Does not require removal during repair soldering (it will peel off when in contact with the hot tip of the soldering iron).
The main difference between PLASTIK HV varnish and PLASTIK varnish is its high viscosity coefficient (30 sec. Versus 12 sec.).
Packing: 100 ml in a glass bottle (repackaged fromcans 5 l ).
Characteristics
color: colorless
density: 0.925 g/cm³
drying time at room temperature: after 25 min. dries before sticking, after 48 hours dries completely
oven drying time: 10-20 minutes at 60-70°C (after preliminary drying at room temperature for 10-15 minutes)
minimum layer thickness: 20-50 μm
consumption (average): 10-20m²/l
operating temperature range: -70°С -+120°С
viscosity: 30s (DIN 53211)
resistance to: acids, salts, corrosive vapors, alcohols, thermal and mechanical influences, alkalis, moisture
surface resistance 5 × 1014; Ω
insulation resistance: 1014Ω
dielectric strength: 21 kV/mm
Appointment
Protection of printed circuit boards, components, transformer and motor windings, etc.
Elimination and prevention of current leaks, corona discharges, short circuits, charge leaks.
Corrosion protection of components exposed to adverse weather conditions.
Moisture protection for various materials such as cardboard, wood, leather, etc.
Recommendations for use
Apply by spray, brush or dip.
If necessary, correct the viscosity with an original solventThinner Plastik.
The use of a non-original solvent leads to unpredictable changes in the properties and quality of the coating!
The surface to be protected must be free from dirt and grease. Apply the aerosol by spraying from a distance of approximately 30 cm, otherwise drips may form on the surface. The clogged nozzle is washed with a solvent, acetone or turpentine.
When applying by spray or brush, it is recommended to cover 2-3 coats with obligatory interlayer drying for about 30 minutes.
Only this product is discussed here. Off topic comments will be deleted! Please follow the Commenting Rules.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Ярослав
unknown
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
