A copy of the famous model Wolfcraft 5019000 (Germany).
Such a device to some extent replaces a pendulum saw, allowing accurate and safe cutting of rolled metal, aluminum radiator profiles, etc., using an angle grinder (LBM) with a 115-125 mm disc as a cutting unit.
The angle of the cutting line is adjusted by turning the vise of the bed at an angle of up to 45 °. The thrust part of the vice is equipped with a graduated scale from 0°to 45 °.
IN
similar bedsan eccentric vise is usually used. When fixing the workpiece with an eccentric, it shifts a little, you have to reinstall it again.
In the same tripod, a vice with a lead screw is used, the jaws move in a plane-parallel manner, without displacement.
The vise and the base of the hinge are fixed on a massive cast-iron base-platform. It does not warp from the applied force, unlike stamped steel platforms. If you need to fix the tripod permanently, there are two special holes for fixing the platform to the workbench. At the corners of the platform, rubber feet are installed at the bottom.
The hinge axis of the pendulum arm is fixed on massive supports, pressed down with plastic pads. This design forms a sleeve bearing.
There is no side play. This also distinguishes this tripod from similar products with a large side play.
The device is equipped with a protective disc guard. Those. before installation, you can remove the original casing from the grinder (this is especially true for cheap grinders with a simplified casing fastening, rigidly fixed in one position).
The set of fasteners includes M8 and M10 bolts - 2 pcs. Different models of angle grinders have different diameters of threaded holes for attaching the handle, for which the machine is attached to the pendulum arm.
Weight 3.2 kg.
Completeness:
-
platform base with a vise fixed on it
-
pendulum arm with hinge assy
-
a set of fasteners for fixing the angle grinder on the device
-
protective cover