Heavy-duty side cutters with antistatic handles for electronics installation work.
Length 125 mm, overlapping fastening, cutting edges of jaws at an angle of 21 degrees to the longitudinal axis of the tool, sharp one-sided sharpening.
The ends of the jaws are blunted.
This sharpening allows you to bite off the leads of soldered components as close as possible to the plane of the printed circuit board.
Ergonomic handles made of non-slip antistatic rubber.
A distinctive feature of this model of cutters is the presence of a spring steel plate attached to the left jaw of the side cutters. This is a limiter that lightly presses the bitten lead (trimming), thereby preventing the trim from rebounding into the radio installer’s face. The clippings bounce to the right.
Recommended use: preparing components for installation, trimming leads on a printed circuit board after soldering.
Characteristics:
-
model: 1PK-5101CE
-
manufacturer: Prokit's Industries Co.,LTD, Taiwan
-
length:125mm
-
material: S50C steel
-
hardness: HRC 50±3
-
handles: antistatic rubber, 1 kOhm ... 100 kOhm
-
cutting capacity: copper up to ∅2.0 mm
-
packaging: blister
-
weight: 105 g
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
